• Easily used by ships maintenance staff right out of the box

  • Instant indication of condition for motor bearings, gears, compressors, slewing rings, hoists, winches...

  • Plan maintenance and have the spares available on time. Minimise off-hire and demurrage.
Quick Contact
This question is for testing whether you are a human visitor and to prevent automated spam submissions.
Enter the characters shown in the image.

Refining Fuel

In the early days of refining, straight run fuel oil was derived from the residue of the atmospheric or vacuum distillation process. Product entering the fuel oil market was of a consistent quality which meant that there were few problems. As demand for distillate products increased, refiners introduced secondary refining processes that affected the fuel oil characteristics.

Refinery slice

In the crude oil distillation process (boiling off), there are four broad fuel product fractions generated in ascending order of boiling point temperature:

  • Refinery gas (primarily methane, ethane and hydrogen)
  • Liquefied petroleum gas (primarily propane and butane)
  • Gasoline and distillate fuels
  • Residual fuel oil

The last fraction, residual fuel is often non boiling, or at least it will not boil without resultant thermal degradation. Distillate fuels are further subdivided into several categories for specific uses again in ascending order of (overlapping) boiling point:

  • Kerosene, used for commercial jet turbine engine fuels, for small heaters etc
  • Diesel, used during cold weather conditions for automotive or truck fuels in "compression ignition" engines
  • Heating oil used for residential heating furnaces and also used in warmer conditions as diesel fuel for larger land-based, on and off-road engines, such as trucks, buses, earth moving and material lifting and moving equipment, farm equipment and railroad diesel locomotives. As gas oil it is used as fuel for industrial heaters and boilers
  • Finally, the "heaviest", or highest boiling point fractions are often blended with residual oil to make fuels for ocean going ships and large industrial steam boilers

The variation of product demand in individual countries is extremely wide and these cannot be accommodated by crude oil selection alone because of the sheer volume required. Furthermore, within any single geographical area, various crude oil sources are used and numerous refinery process configurations are employed. The result of this is that on a worldwide basis, fuel for the industrial and marine markets is subject to considerable variation in its properties. Whilst this has basically always been the case, the variations can be more pronounced than they have been in the past. Some effects of the secondary refining are:

  • Increased density
  • Increased micro-carbon residue (MCR)
  • Increased asphaltene (high molecular weight hydrocarbon) content
  • Possible increased compatibility and stability/sediment problems
  • Increased possibilty of contamination by catalyst fines as more cycle oil slurry is used as cutter stock


Off-line Bunker Fuel

Latest News

Parker Kittiwake Launches New CAT Fines Test Kit
Test kit detects catalytic fines to prevent irreparable damage to fuel pumps, injectors, piston ring... Read More...
Switching Fuel Oil and the Risk of Loss of Propulsion
Nearly nine months have passed since the 0.1% sulphur limit for marine fuels in designated Emissions... Read More...
Measuring Ferrous Wear: the FWM vs. the Analex fdMplus
When it comes to detecting and analysing machine wear, testing for ferrous density – the prese... Read More...